Yaskawa DS391 - Manual (Page 2)

DWG. NO. 02Y00025-0297
SHEET NO. 2 OF 7
REL. 01/30/91 ( m - d f )
Refer to Sheet 1 for latest change.
Figure 2. Installation of Analog Monitor (AO-08) or (AO-12) in GPD 503 or VCD 703
FRONT
COVER
AO-08 or AO-12
OPTION
BOARD
DIGITAL
OPERATOR
MAIN
CONTROL
BOARD
PLASTIC
STANDOFFS
ON MAIN
BOARD
2CN
3CN
Figure 1. Installation of Analog Monitor (AO-08) or (AO-12) in GPD 515
NOTE: If this option is being installed on a GPD 515 with speed fedback, the speed feedback card needs to
be temporarily un-installed to allow access to the connector 2CN on the Drive’s Control Board and TD1, TD2 &
TD3 on the AO-08 or AO-12 option card.
4. See Figure 1 (GPD 515) or Figure 2 (GPD 503 or VCD 703). Install the option on the Main Control Board,
1PCB, and ensure 3CN is properly connected. Make sure Electrostatic procedure is followed.