Yaskawa DeviceNet with ADR Option Kit CM012 - Manual

DeviceNet™ With ADR Option Kit
CM012
Yaskawa Electric America, Inc. – www.yaskawa.com
IG.AFD.16, Page 1 of 7
Date: 06/15/2007 Rev: 07-06
Applicable products: F7U, G7U, P7U, G5M (Spec F), and G5M (600V)
drives. For G5U (HHP) drives, refer to IG.G5HHP.16.
1. Unpack the DeviceNet Option Kit CM012 and verify that all components
are present and undamaged.
2. Connect power to the Yaskawa AC drive and verify that the drive
functions correctly.
This includes running the drive from the operator keypad. Refer to the
appropriate drive technical manual for information on connecting and
operating the drive.
3. Remove power from the drive and wait for the charge lamp to be
completely extinguished.
Wait at least five additional minutes for the drive to be completely
discharged. Measure the DC bus voltage and verify that it is at a safe level.
4. Remove the operator keypad and drive cover.
a. Remove the operator keypad.
b. Remove the terminal and control covers.
c. Remove the option card hold-down plug by carefully compressing the
top and bottom until it becomes free of its holder. Lift it out.
5. Mount the DeviceNet Option Card.
a. Remove the DeviceNet connector and attach the DeviceNet network
cable as shown below.
b. Reconnect the DeviceNet connector to the Option Card.
c. Align the J2 connector on the back of the DeviceNet Option Card to its
mating 2CN connector on the front of the drive control board.
d. Align the two stand-offs on the front of the drive control board with the
two holes on the right side of the DeviceNet Option Card.
e. Press the DeviceNet Option Card firmly onto the drive 2CN connector
and stand-offs until the J2 connector is fully seated on 2CN and the drive
stand-offs have locked into their appropriate holes.
f. Route the DeviceNet network cable along the left inside of the drive
enclosure.
g. Replace the Option Card hold-down plug.
Note: Do not ground the DeviceNet Option Card (UTC000180).
DeviceNet Option Kit CM012 Parts Qty.
DeviceNet Option Card (UTC000180) 1
Installation Guide (IG.AFD.16) 1
WARNING
Dangerous voltages in excess of 400VDC (230V drives) or 800VDC
(460V drives) are present at the DC bus terminals of the drive.
Option card
hold-down plug