Yaskawa G5 Traverse Control - Manual

Traverse (P-Jump) Control
Date: 07/01/04, Rev: 04-07 Page 1 of 7 TM.G5SW.005
G5+ Software Option
Software Number: VSG111061
Part Number: CIMR-G5MXXXXXF-005
(1)
With this factory-installed FLASH software, the
GPD515/G5 has the ability to modulate the
output frequency around the set frequency
reference. This function provides an evenly
wound roll for those winding applications that
would experience localized build-ups without
this feature. The terms disturb, p-jump, ribbon
break and wobbulator are also used to
describe this function. Specifications:
• P-Jump Function / Inertia Compensation
• P-Jump ON/OFF Select
• P-Jump Limit
• Adjustable Duty Cycle
• Sawtooth Waveform Generation / Ribbon
Break
• Percent Trim Adjustment
• Independent P-Jump Adjustment
• Independent Accel/Decel Times
• Control Mode: P-Jump in V/f only
• Serial Communications: DeviceNet,
Profibus, Modbus Plus, Modbus RTU.
This document is an addendum to Technical
Manual TM4515, listing the effect of this
software on the parameters in the drive and
function descriptions in the manual.
(1) XXXX refers to the base Model Number of
the drive in which the software is installed.