Yaskawa G5 Traverse Control - Manual (Page 5)

Date: 07/01/04, Rev: 04-07 Page 5 of 7 TM.G5SW.005
4.3 New Program Parameters
The Traverse (Disturb) function give the drive the ability to change speed in a regular
pattern from a steady frequency reference. Traverse changes the speed of the
motor/winder so that the material being wound build up evenly.
Figure 1: Disturbed Speed Reference When Using the Traverse Function
Disturb WF Sel
P1-01 = 1
P1-01 Disturb WF Sel
Setting Range:
0 to 1
Factory Default: 1
Modbus Address: 0580H
Setting Description
0 Disturbed speed reference is disabled
1 Disturbed speed reference is enabled