Yaskawa AC Drive - A1000 Option Hz High Frequency Custom - Manual (Page 11)

4 Modified Parameters
YASKAWA TM.A1000SW.056 YASKAWA AC Drive - A1000 Custom Software Supplement 11
Table 7 MEMOBUS/Modbus Communication Data
Table 8 Deleted Parameters from Standard Software
Register Name Revised Content
0010H Frequency Reference RPM Deleted
003EH Output Frequency RPM Deleted
00ACH Motor Speed RPM Deleted
00B5H Frequency Reference After Soft-starter RPM Deleted
00B7H Frequency Reference RPM Deleted
Parameter Name
A1-06 Application Preset
b1-05 Action Selection below Minimum Output Frequency
b2-08 Magnetic Flux Compensation Value
b3-06~12 Estimation Type Speed Search
b3-24 Speed Search Method Selection
b8-01~03 Energy Saving Control (OLV)
b8-01,04~14 Energy Saving Control (V/f)
b8-01,16~18 Energy Saving Control (PM)
b9-01,02 Zero Servo
C3-05 Output Voltage Limit Operation Selection
C3-06 Flux Characteristics Selection
C3-15 Lower Limit Frequency for Slip Compensation during Regen
C3-21 Motor 2 Slip Compensation Gain
C3-22 Motor 2 Slip Compensation Primary Delay Time
C3-23 Motor 2 Slip Compensation Limit
C3-24 Motor 2 Slip Compensation Selection during Regeneration
C3-25 Motor 2 Lower Limit Frequency for Slip Compensation during Regen
C4-03 Torque Compensation at Forward Start
C4-04 Torque Compensation at Reverse Start
C4-05 Torque Compensation Time Constant
C4-06 Torque Compensation Primary Delay Time 2
C4-07 Motor 2 Torque Compensation Gain
C5-05,11,12, 21~35 ASR
C5-17,18, 37,38 Load Inertia
C6-14,15,16 Swing-PWM
D4-11 Bi-Directional Function Selection
D4-12 Simple Positioning Gain
D5-01~06,08 Torque Control
D6-03,06 Field Forcing
E2-07 Motor Iron-Core Saturation Coefficient 1
E2-08 Motor Iron-Core Saturation Coefficient 2
E2-09 Motor Mechanical Loss
E2-12 Motor Iron-Core Saturation Coefficient 3
E2-13 Leakage Inductance Current Saturation Characteristics
E3-01~13 V/f Characteristics for Motor 2
E4-01~16 Motor Parameters for Motor 2
F1-01,31 PG 1/2 Pulses Per Revolution
F1-02,14 PG Open Circuit Detection
F1-05,32 PG 1/2 Rotation Selection
F1-06,35 PG 1/2 Division Rate for PG Pulse Monitor
F1-12,13,33,34 PG 1/2 Gear Teeth