iSys iTerra Elite Color LED Printer - Manual (Page 25)

PAGE 25 --- Auto Stacker User Guide © 2008. All Rights Reserved. iSys-The Imaging Systems
Group Inc.
image 25
13 Plug the power adaptor into the Auto
Stacker DC power jack and watch the
LED’s on top of the stacker. Take note
on how many times the yellow LED
flashes.
See section 7.4 on page 31 to learn how
to set the printer type. This will also allow
you to choose between iTerra Pro &
iTerra Elite.
image 26
*NOTE: On power up check the Yellow LED for the number of flashes (1x=Pro, 2x=Elite)
this must match the printer type.
Connect the other end of the control
cable (3 pin) to the back of the printer’s
lid.
(see image 25) 11
12 If you have a iTerra PRO or Elite printer
with the top JAM box you must connect
the rear jam wheel connector to the
underside of the Auto Stacker’s side
cover as shown in image 26.