iSys iTerra Elite Color LED Printer - Manual (Page 26)

PAGE 26 --- Auto Stacker User Guide © 2008. All Rights Reserved. iSys-The Imaging Systems
Group Inc.
6. HEIGHT ADJUSTMENT
NOTE: Ensure that you have installed the support bracket correctly under
the printer before you continue with these steps.
a. Use a 1/8” allen key to hold the height adjustment set screw
of the support bracket on the side that needs to be adjusted
and use a 7/16” wrench to loosen its locking nut (see image
27).
image 27
b. Turn the set screw up or down as required while pushing the
top of the Auto Stacker against the back of the printer until
the top of height Setup Jig is in line with the bottom of the
printer’s left and right lid support horns as shown in step 6.