LeMond RevMaster Pro User Manual

Page 13

Advertising
background image

Pg. 11

INSTALLATIoN ChECk LIST

stAbilizer bArs
Check that the mounting screws, four M8 x 20 screws attach the front stabilizer bar to the frame, and

four more attach the rear stabilizer, are properly aligned (not cross threaded) and use the correct

washers . Check that the top mounting screws use an M8 star washer, and that the bottom mounting

screws use a curved washer, with the concave surface facing the stabilizer . Check that the screws are

securely tightened .

PedAls

Left Crank

Left Pedal

Insert

Counter-Clockwise

Check that the pedals are not cross threaded into

the crank arms . The right pedal has a normal thread

pattern (clockwise to tighten, counter-clockwise to

loosen), and left pedal has a reverse thread pattern

(counter-clockwise to tighten, etc .) . When installing

the pedals, use your fingers to start the pedal so you

can feel if you are cross threading them into the crank

arms . Use a 15mm box end wrench to tighten the

pedals after you have installed them finger tight .

hAndlebAr
When the handlebar is installed, the slider plunger (see figure below) may become dislodged . If this

happened during assembly, the adjustment lever alone will not provide a sufficient grip to secure the

handlebar to the mounting track; if threaded up against the mounting track, it could damaging the

track .

Slider Plunger

If the slider plunger is missing, see Handlebar Adjustment and

Assembly below for instructions on replacing the slider plunger

and installing the handlebar .

seAt slider
Ensure that the large brass washer is installed on the adjutment

handle attaching the seat slider to the seat post . (See Figure 1 .)

Apply a small amount of grease to the threads to allow adjustments .

wAter bottle holder
The water bottle holder is attached with an M5 countersunk screw to the bottle holder front mount . If

the bottle holder is not already attached, remove one of the one of the M5 countersunk screws from

the front mount with a 3mm hex wrench and use it to attach the bottle holder to the bracket .

Advertising