LeMond RevMaster Pro - Manual (Page 29)

Pg. 27
AdJustment hAndles (hAndlebAr/seAt Post heiGht AdJustment hAndles)
Use 6mm hex wrench & 3mm hex wrench to adjust the handles .
Adjustment
Handles need to be unlocked to adjust the tightness of the handle against the post . Lift up on the
handle to unlock and lower the post until it bottoms out . If adjusting the seat post, first remove the
seat with the seat slider from post so the fore/aft adjustment handle is out of the way . Loosen the
screw on right side of bike one turn with 3mm hex wrench . Push in on this screw so the 6mm screw
(Post Handle Pin) on the other side disengages from the teeth in the indicator plate .
To increase the handle pressure on the post, rotate the 6mm screw towards the (+) sign by 1 tooth while
lifting up on the handle . Then push the screw in so it locks into the teeth on the indicator plate and let
go of the handle . Tighten the 3mm screw on the right side of the bike and raise the post up and test .
Repeat the process if more pressure is needed .
To decrease the handle pressure on the post, rotate the 6mm screw towards the (-) sign by 1 tooth while
lifting up on the handle . Then push the screw in so it locks into the teeth on the indicator plate and let
go of the handle . Tighten the 3mm screw on the right side of the bike and raise the post up and test .
Repeat the process if the handle is hard to lock down and less pressure is needed .