LeMond RevMaster Pro - Manual (Page 24)

Pg. 22
RevMaster Service Manual
Flywheel
Use a 5mm hex wrench to remove flywheel assembly & 4mm hex wrench to remove flywheel hub as-
sembly from flywheel . Also use medium 242 strength Loctite .
Removal
Remove belt cover, drive belt and fender assembly and raise handlebar post to a higher position . It
is also helpful to raise the brake rod up and wrap a piece of electrical tape around the brake shaft,
just above the brake nut to prevent the bottom of the rod from getting in the way . Using a 5mm hex
wrench, remove the two pillow block screws (M6 x 35) from right pillow block and the two pillow block
screws (M6 x 35) from the left pillow block . Before removing the flywheel assembly, please note it is
heavy and weights 48lbs . Carefully lift the flywheel so the pillow blocks unseat themselves from the
frame and slowly move the flywheel forward out of the frame . Be careful not to scratch or dent the
surface of the flywheel . If needed, a rag can be put under the flywheel when removing to provide a
softer surface .