LeMond RevMaster Pro - Manual (Page 21)

Pg. 19
drive belt/drive belt tension
Use a 5mm hex wrench (long T-handle works best) & 8mm hex wrench to remove/install or adjust drive
belt .
Please use caution around drive belt when installing, removing or adjusting belt .
Removal
Remove belt cover . Loosen the shoulder bolt of idler bearing assembly ¼ turn with a 8mm hex wrench .
Loosen the tension screw (M6 x 60) with a 5mm hex wrench until the idler bearings can be pushed to the
top of the slot in frame and bearings are loose enough to allow you to remove the drive belt from the
pulleys .
IInstallation
Wrap the drive belt around the front flywheel pulley . Pass the top of the belt under the tensioner bear-
ings (tensioner bearing assembly should be loose and able to move freely in slot) and over the top of the
rear crank pulley . Continue feeding the belt onto the crank pulley while working your way counterclock-
wise . If the belt is too tight near the bottom to slide over the pulley, keep tension on the belt and slowly
rotate the right crank arm counterclockwise to walk the rest of the drive belt onto the pulley . Check to
make sure the belt is centered on both pulleys and the upper portion of the belt is under the tensioner
bearings . Also check that the idler spacer located directly behind the idler bearings is still sitting on the
shoulder bolt with the bearings .