LeMond RevMaster Pro - Manual (Page 20)

Pg. 18
RevMaster Service Manual
belt cover
Use a 3mm hex wrench & 5mm hex wrench to install/remove belt cover .
Removal
Remove the three 3mm screws from left side (non-drive side) of the bike . Rotate the right crank arm to
the 10 o’clock position . Remove the four 5mm screws from the right side (drive side) and remove belt
cover . Please note: Always use caution around drive belt when cover is removed .
Installation
Rotate the right crank arm to the 10 o’clock position . Pass the right crank arm through hole of belt cover
and line up screw holes of belt cover with threaded holes in frame of bike . Insert and gently snug down
each of the 5mm screws from the right side and each of the 3mm screws from the left side .