Eaton Electrical Powerware 9315 - Manual (Page 23)

4-1 EATON Powerware
®
9315 UPS (200–300 kVA) Operation Manual S 164201036 Rev F powerware.com
Chapter 4 Starting and Stopping the UPS
This chapter describes how to use the Control Panel to start and stop the UPS.
NOTE Before starting the UPS, ensure all installation tasks are complete and a
preliminary startup has been performed by authorized service personnel. The
preliminary startup verifies all electrical interconnections to ensure the installation
was successful and the UPS system operates properly.
4.1 Using the Control Panel
The Control Panel is inside the right-hand door of the UPS cabinet (see Figure 4-1).
Although the Control Panel appears easy to use, you should read these instructions and
thoroughly understand how the controls work before attempting to use them.
C A U T I O N
Incorrect use of the power controls on the Control Panel can cause a loss of power to the
protected equipment.
Figure 4-1. UPS Control Panel