Casio DT-900 - Manual (Page 38)

E-40
Using the Satellite Cradle
When You Are Using the Down-facing Reader Port Model
When you are using a down-facing reader port model, remove the nose guide before use.
To remove the nose guide, remove the two
screws using a screwdriver.
Setting up the Satellite Cradle and Connecting the Data
Collector
Use only the specified AC Adaptor for Satellite Cradle to connect to an electrical outlet. Be
sure to connect the AC adaptor and turn on Satellite Cradle power before performing any
data communication operation with the Data Collector. Power is supplied to the Data
Collector by the Satellite Cradle.
1
Plug the AC adaptor into an electrical outlet.
2
After making sure that the power switch of the
Satellite Cradle is in the OFF position, plug
the other end of the AC adaptor into the AC
terminal at the top of the Satellite Cradle.
3
After making sure that the power of the
Satellite Cradle and personal computer is
OFF, remove the cover and connect one end
of the optional RS-232C cable (DT- 881RSC,
DT-882RSC, DT-883RSC, DT- 887AX/AXA)
to the RS-232C connector at the top of the
Satellite Cradle. Connect the other end of the
cable to the computer’s RS- 232C connector.
When the RS-232C connector is not used,
attach the cover.
Power
switch (OFF)
To electrical outlet