Casio DT-900 - Manual (Page 40)

E-42
Using the Satellite Cradle
Charging the Battery Pack
The following procedure can be used only when a lithium-ion battery pack is loaded in the
Data Collector.
1
Turn on the power of the Satellite Cradle, and
confirm that its power indicator lights up red.
2
Attach the Data Collector to the Satellite
Cradle, making sure that the charge terminals
on the rear of the Data Collector come into
contact with the charge terminals on the
Satellite Cradle. The color of the Satellite
Cradle power indicator changes to green
when proper connection is achieved. The
charge indicator lights up red when charging
starts.
Charge Indicator
Lit Red:
Charging
Lit Green: Charging complete
When the charge indicator lights red and
then goes out after several seconds, this
indicates a battery problem.
Charging Time
Approx. 6 hours
[Warning]
■ Pay Attention To The Ambient Temperature When Charging The Battery Pack
• Temperature ranges for battery pack use, charging, and storage are
specified below. Temperatures outside these ranges create the danger
of deterioration of battery pack performance and shortening of its
service life, as well as fluid leakage and heat generation.
Operating Temperature: –5°C to 50°C
Charging Temperature: 0°C to 40°C
Storage Temperature: –20°C to 60°C
Important! • If the charge indicator does not light during charging, remove the
battery pack and then re-attach it. If this does not solve the problem, it
means that the battery pack is defective and needs to be replaced.
• Use only the specified battery pack.
• Battery packs naturally discharge even when they are not loaded in the
Data Collector. Use a battery pack as soon as possible after charging it.
• For best charging results, keep the Satellite Cradle, Data Collector and
battery pack contacts clean by periodically wiping them off with a
cotton swab or dry cloth.
Charge terminals
Power
switch (ON)
System operation indicator
Charge indicator
Data communication indicator
Battery pack charge indicator
Power indicator