Casio SE-C3500 Manual - Manual (Page 94)

E-94
Programming functions of departments and PLUs in a lump
There are two methods to set functions of departments or PLUs which are programming at once and
programming individual functions.
Programming department and flat PLU functions in a lump
This method programs function of a department at one time.
For shifted departments, press <Department no./Department shift> key first.
For shifted flat PLU, press @ key first.
Step Operation
1
Turn the Mode switch to PGM position and select [System
Setting] then press F key.
> ▪▪▪▪▪ >F
2
Enter 3 and press o key to set the register in the
programming mode.
3o
3
You can skip this step if you program in departments 01
through 25. If you wish to program in departments 26
through 50, press <Dept.no./Dept. shift> key.
<Dept.no./Dept. shift>
4
Referring following table, input 12- digit program code.
BB ▪▪▪▪▪ BB
[Program code (12 digits)]
5
Press the department key you wish to program !
For example, programming in dept. 26.
6
Repeat steps 3 through 5 if you wish to program functions
in another departments.
7
Press o key to complete the program. o
Example:
Programming department 26 as;
• Normal item: D12 = 0.
• D11 through D8 must be 0000.
• US taxable status 1 (a = 1) and 2 (b = 2): D7 = 3 (1 + 2)
• Allowing zero unit price (a = 1), not allowing negative unit price (b = 0), hash item (c = 4): D6 = 5 (1 + 0 +
4).
• D5 must always be 0.
• Limiting minimum entry digit: 3 digits: D4 = 3.
• As this example is for setting functions in a department, D3 should be 0.
• Applying commission 1 (a = 1), not applying commission 2 (b = 0): D2 = 1 (1 + 0).
• D1 must always be 0.
Press
3o@00000350301!o
Advanced programmings and registrations