2 protection alarms, 3 multi ups systems and notification alarms, 4 multi ups systems and protection alarms – Eaton Electrical V3 User Manual

Page 53: Protection alarms, Multi ups systems and notification alarms, Multi ups systems and protection alarms

Advertising
background image


www.eaton.com





Network Shutdown Module V3 – User Manual - 34 003 934 XU / AE

Page 52/65

z

Communication failure

Communication between Network Management Card/Proxy and UPS (or

NSM) has failed
or [Communication between Network Management Card/Proxy and UPS is restored]

7.8.2.2 Protection alarms

These alarms are mainly dedicated to trigger operating system shutdown actions:

z

Shutdown criteria is reached

One of the criteria for which the system should be shutdown has

been reached

z

Redundancy lost The installation has no redundancy source available anymore
or [The installation has one or several redundancy source available]

z

Protection lost

The number of sources ensuring your installation protection is not sufficient

or [The number of sources ensuring your installation protection is sufficient]

7.8.2.3 Multi UPS Systems and Notification Alarms

With default configuration, the Network Shutdown Module considers that the “Notification Alarms” don’t trigger
the shutdown. (only the notification action is performed).


Anyway it is possible to configure a “Shutdown action” when a “Notification Alarm” event is received.
In this case:

z

The first alarm reception (from one of the UPSs) will trigger the system shutdown.

7.8.2.4 Multi UPS Systems and Protection Alarms

z

Shutdown criteria is reached.
With default configuration, the Network Shutdown Module triggers the shutdown when this event is
received.

Anyway it is possible to configure a “Shutdown” action when the following events are received.

z

Redundancy lost alarm
If the user configures a “Shutdown action” when a “Redundancy lost” event is received, the shutdown will
occur when the installation has no redundant source available anymore.
The redundancy Level is configured in Configuration-> Power Devices screen
Following Alarms are taken into account for this alarm :

>

UPS fault (internal fault or battery fault)

>

Communication failure,

>

Output on bypass,

>

UPS Stopped.

z

Protection Lost Alarm
If the user configures a “Shutdown action” when a “Protection Lost” event is received, the shutdown will
occur when the number of sources ensuring your installation protection is not sufficient.

>

Only following UPS faults are taken into account (internal fault or battery fault).

>

The By-Pass events (Automatic or Manual) for maintenance reasons are not taken into account.

Advertising