Epson Bocs User Manual
Page 22
Programming the Remotes
22
6.
Press the Select/OK button to accept the new code.
Step 4: Program the rest of your remotes for each room
This is exactly like step 2 – just grab a new remote, make sure it is Paired to your
Xtender, and program it for the TV in the room where you intend to leave that
remote.
Step 5: Set the master remote
Note
you only need to perform this step if you have connected a TV to the “Local TV”
coax connector on the Xtender
The "Local Master" remote is defined as the remote that controls the TV that is
connected to the "local TV" coax output from the Xtender. This remote must
identify itself to the Xtender so that the Xtender can switch the correct output
signal onto the "local TV" output, depending on whether the TV is tuned to a TV
channel or a BOCS channels. This switching allows you to watch TV channels that
would otherwise be replaced by the BOCS channels. When you press the red,
green, or blue button on the "Local Master" remote, the Xtender switches BOCS
channels onto the "local TV" coax output. When you press the "Local TV" button,
the Xtender changes the switch to output CATV signals to the "local TV" coax
output.
To set or remove the remote as a "Local Master"
1.
Press and hold one of the following combinations for at least 2 seconds:
"Menu" and "Vol +" to set the remote as local master.
"Menu" and "Vol -" to remove the remote as local master.
2.
The Power LED will turn on.
3.
Press Select/OK to confirm.
4.
If successful, the power LED will pulse twice and turn off. If the function failed, the
power LED will pulse rapidly for one second, and then turn off.
That’s it! You are ready to begin using your Xtender system. Enjoy