Epson Bocs - Manual (Page 33)

Programming the Remotes 33
pointed there until the TV goes where
you want - some TVs take a while to
respond. if the TV only sees one digit,
wait until that clears before you try
pushing the Xtender channel button
again.
One other thing to watch for, some TVs
need a long time in between pressing
buttons - if you press the Red button
(and have the default configuration
where red is on channel 14) and you see
the 1 on the TV but the 4 never shows up,
see the next FAQ item "When I push an
Xtender channel button on the remote it
only sends one digit".
When I push an
Xtender channel
button on the remote
it only sends one
digit Some TVs need a long time in between
pressing buttons - if you press the Red
button (and have the default
configuration where red is on channel
14) and you see the 1 on the TV but the 4
never shows up (and you were a good
user and kept the remote pointed right at
the TV), it is likely that the remote is
sending the channel commands too
quickly. We have noticed some Insignia
TVs and a few others have this problem.
The tradeoff is that it will take longer to
change between Xtender channels, but
since the alternative is not ever getting
there, we suggest the following:
Quick - pre-explanation first...
What actually happens when you push
the Red button is the remote sends a "1"
then pauses then sends a "4" ...
Depending on the TV, a different "pause
time" is required - for now you will have
to play with it a little to get it just right (as
we get more feedback from users we will
publish a detailed pause-time list for
various TV models - so if you don't mind
let us know what works for you if you
have to adjust this in your house)...
To set the pause time,
Hold down the MENU button and the "4"
key: The power light should come on and
stay on
press one of the following and then