Epson Bocs - Manual (Page 27)

Programming the Remotes 27
ƒ 1 = send two digits for channel 99 or lower; send "+100" followed by
two digits for channel 100 and above. This is the default.
ƒ 2 = always send three digits.
3. Press Select/OK to confirm.
4. If successful, the power LED will pulse twice and turn off. If error, the power
LED will pulse rapidly for a second, then turn off.
Adjust the Video quality of Xtender channels
Important The Xtender can be adjusted to output different levels of video to the home, this
provides the ability to make Cable-TV channels and Xtender channels look the
same.
1. Set up the desired television to view the CATV signal, and make a note of its
signal quality.
2. Switch the television to view a BOCS channel.
3. Press and hold the "Menu" and "1" for at least 2 seconds.
4. The power LED will turn on.
5. While observing the BOCS signal on the television, press the up arrow or down
arrow as appropriate to optimize the signal.
6. When you have found the best gain setting, press Select/OK to confirm. To exit
without changing the gain, press any other button, or just wait 10 seconds for
the function to time out.
Note when either the maximum or minimum range of the attenuator is reached, the
power LED will flash rapidly for one second, then revert to full on. The full range of
the attenuator can be spanned in about 8 seconds.
Note that sometimes the problem is an Xtender channel that has “too much signal,” so
if the picture does not look good, also try turning the level down. You should find a
level that makes Xtender channels look good on all your TVs.