Epson Bocs - Manual (Page 44)

Auxiliary Device Codes 44
Show Current IR Codes programmed into the remotes
This function outputs an indication of the IR codes currently set for all the local IR
devices and the devices attached to the BOCS red, green, and blue channels, by
flashing the corresponding LEDs on the remote. Once you get your system up and
running well, it is a good idea to record all the codes you are using in case you ever
need to reprogram the system.
The device types are displayed using the following code:
• Each device type is flashed as five digits.
• Digits 1 through 9 are indicated by one through nine LED flashes, respectively. For each flash the
LED is on for ½ second and off for ½ second.
• Digit 0 is indicated by a rapidly flashing LED for 1 second.
• The LED is off for two seconds between digits.
Procedure:
1. Press and hold "MENU" and "2" on the remote for at least 2 seconds.
2. The power LED will turn on.
3. Press Select/OK to confirm.
4. The red LED will flash the device type for the red channel device.
5. The green LED will flash the device type for the green channel device.
6. The blue LED will flash the device type for the blue channel device.
7. The Local TV LED will flash the device type for the local TV device.
8. The AUX LED will flash the device type for the local AUX device.
9. The DVD LED will flash the device type for the local DVD device.
10. The CBL LED will flash the device type for the local CBL device.
11. The power LED will turn off.