Equator MD3720CEE - Manual (Page 16)

16
5) Hot water valve (00821)
Replacement Procedure:
▪
Unplug the unit.
▪
Remove the top panel (Two screws behind and slide back)
▪
Unfix the two screws at the back which hold the hot water valve.(Marked H)
▪
Remove the clamp to the hose.
▪
Replace with the new valve and do the wiring as before / below.
▪
Fix all the parts back by following the reverse procedure.
Wiring: Hot water Valve
Testing Procedure:
▪
Hot Test:
1) Set the washer knob to the Towels / Sheets position and switch on the unit.
2) You should get 115V AC between the terminals EVCX & EVC and the unit should start
filling in with water, it the unit does not start filling the valve is bad.
e Please Note: The door should be locked properly and there should be enough
pressure to the water supply.
EVC
EVCX