Equator MD3720CEE - Manual (Page 26)

26
15) Speed Regulator (00791)
Replacement Procedure:
▪
Unplug the unit.
▪
Remove the top panel (Two screws behind and slide back)
▪
The speed regulator is located on the right hand side at the back of the unit.
▪
Unfix the housing of the speed regulator. (2 screws at the back)
▪
Slide out the speed regulator and replace the same.
▪
Do the wiring as before / below.
▪
Fix all the parts back by following the reverse procedure.
Wiring: Speed Regulator
e Please Note:
1) The wiring should be done as above, if you operate the unit interchanging
a single wire there is a possibility that the speed regulator goes bad
immediately.
RV1
RV2
RVF
RV3
RV4
RV5
RV6
RV7