Equator MD3720CEE User Manual
Page 28
28
17) Main Motor (50751)
Replacement Procedure:
▪
Unplug the unit.
▪
Make sure that there is no water in the unit.
▪
Remove the back panel (3 screws at the back)
▪
Remove the belt.
▪
Tilt the unit towards the left and carefully lay down the unit on the side.
▪
Unfix the four leveling legs and remove the bottom panel.
▪
The motor is supported with 3 bolts, unfix the same and replace the motor.
▪
Do the wiring as before / below.
▪
Fix all the parts back by following the reverse procedure.
Wiring: Main Motor
Testing Procedure:
▪
Cold Test:
1) Check the resistance between the following terminals, if the results match near about,
the motor is fine.
Sr. No
Terminals
Resistance
1
1 & 2
7.8 – 8.6
2
1 & 6
2.8 – 3.4
3
2 & 6
10.6 – 12.0
4
3 & 5
9.5 – 9.8
5
5 & 7
9.5 – 9.8
6
3 & 7
13.0 – 13.6
7
4 & 8
29.4 – 31.0
e
Please Note: Adjust the belt tension after replacing the motor.
4
8
7
3
6
2
5
1
M2
M5
M1
M6
M7
M3
M4 M8
Holes for Bolts