HP EliteBook 840 G3 - Manual (Page 70)

6. Use a pointing device or the arrow keys to select an internal hard drive, and then press enter .
7. Use a pointing device or the arrow keys to select Disable protection.
8. Type your master password, and then press enter .
9. Clear the DriveLock password on restart check box, and then read the warning. To continue, select OK.
10. To save your changes and exit Computer Setup, select the Exit icon in the lower-right corner of the
screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Main > Save Changes and Exit, and then press
enter .
Your changes go into effect when the computer restarts.
Using Computer Setup Automatic DriveLock
In a multiple-user environment, you can set an Automatic DriveLock password. When the Automatic DriveLock
password is enabled, a random user password and a DriveLock master password will be created for you. When
any user passes the password credential, the same random user and DriveLock master password will be used
to unlock the drive.
NOTE: A BIOS Administrator password must be set before you can access the Automatic DriveLock features.
Entering an Automatic DriveLock password
To enable an Automatic DriveLock password in Computer Setup, follow these steps:
1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen.
2. Press f10 to enter Computer Setup.
3. Use a pointing device or the arrow keys to select Security > Hard Drive Tools > Automatic DriveLock,
and then press enter .
4. Enter the BIOS Administrator password, and then press enter .
5. Use a pointing device or the arrow keys to select an internal hard drive, and then press enter .
6. Read the warning. To continue, select YES.
7. To save your changes and exit Computer Setup, select the Exit icon in the lower-right corner of the
screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Main > Save Changes and Exit, and then press
enter .
Removing Automatic DriveLock protection
To remove DriveLock protection in Computer Setup, follow these steps:
1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen.
2. Press f10 to enter Computer Setup.
3. Select BIOS Administrator, and then enter the BIOS Administrator password.
4. Use a pointing device or the arrow keys to select Security > Hard Drive Tools > Automatic DriveLock,
and then press enter .
60 Chapter 9 Security