Epson Stylus Scan 2500 - Manual (Page 5)

5
A Few Precautions
English
■
Unplug the Stylus Scan and refer servicing to qualified service personnel under any
of the following conditions:
The power cord or plug is damaged; liquid has entered the Stylus Scan; the Stylus
Scan has been dropped or the cabinet damaged; the Stylus Scan does not operate
normally or exhibits a distinct change in performance.
■
To provide adequate short-circuit protection and over-current protection for this
Stylus Scan, the building installation must be protected by a 16 Amp circuit breaker.
This device contains batteries and should not therefore be disposed of
with normal domestic waste. Please dispose of the device in accordance
with local statutory regulation.
A Few Precautions
❚ When using the Stylus Scan
■
Do not put your hand inside the Stylus Scan or touch the ink cartridges during
operation.
■
Do not move the print head by hand. Doing so may damage the Stylus Scan.
■
Always use the
P power button to turn off the Stylus Scan. When this button is
pressed, the Operate light flashes briefly then goes off. Do not unplug the Stylus
Scan or turn off the power to the outlet until the Operate light stops flashing. The
scanner carriage must be secured with the Transportation Lock.
■
Before transporting the Stylus Scan, make sure the print head is in the home (far
right) position and the ink cartridges are in place. The scanner carriage must be
secured with the Transportation Lock.
❚ When handling the ink cartridges
■
Keep ink cartridges out of the reach of children. Do not allow children to drink the
ink or otherwise handle the cartridges.
■
If ink gets on your skin, wash it off with soap and water. If ink gets into your eyes,
flush your eyes immediately with water. If a discomfort or vision problems remain
after a thorough flushing, see a doctor immediately.
■
Do not shake the ink cartridges. Cartridges may leak if shaken.
■
Install the ink cartridge immediately after you remove it from its package. Leaving
the cartridge unpacked for a long time before use may result in reduced print quality.
■
Once you install an ink cartridge, do not open the clamp or remove the cartridge
except to replace it with a new one. The cartridge becomes unusable when you open
the clamp.
■
Do not use an ink cartridge beyond the date printed on the cartridge carton. For best
results, use the ink cartridges completely within six months of installing them.