RISCO Group Industrial LuNAR - Manual (Page 21)

Ind. LuNAR RK200DTG3 Installation Guide 19
Terminal Blocks
TERMINAL BLOCK 1 DESCRIPTION
+12V (RED) Power supply positive (+) input voltage
- (BLK) Common to control panel power supply
BUS (GRN) Used for data communication with the ProSYS
BUS (YEL) Used for data communication with the ProSYS
SET ∗ Used to remotely SET/UNSET the detector.
When an activation signal (see RC/SET Activation jumper for settings) is applied to the
SET input of the terminal block:
 AM will be disabled (if the AM DIP switch 5 was previously ON)
 MW module is enabled (if the Green Line DIP switch 3 was previously ON).
Removing an activation signal will cause a Self Test (if the Remote Self Test DIP switch
4 was previously OFF).
RC ∗
(REMOTE
CONTROL)
Used to enable/disable the remote control communication, only when DIP switch 7 is
“OFF”.
When an activation signal (see RC/SET input jumper for settings) is applied to the RC
input of the terminal block, Remote Control will be enabled.
Note: DIP switch 7 “ON” constantly enables RC communication.
WARNING:
Turn DIP switch 7 “OFF” after installation and when leaving the site for security
reasons. This will prevent unauthorized use of a remote control unit that may be used
to disable the detector.
∗
Not relevant in BUS mode
TERMINAL BLOCK 2 DESCRIPTION
AM/FAULT Normally closed output
The AM/FAULT output opens in the following events:
 Detector is masked (ALARM also opens in this case)
 Self Test failed
 Input voltage is low (6VDC-8VDC)
TAMPER Normally closed output
ALARM Normally closed output
Eng
lish