RIGOL DG1000Z Series - Manual (Page 54)

RIGOL
10 DG1000Z Quick Guide
modulation source is selected, this connector accepts an external
modulation signal.
—
FSK: when ASK, FSK or PSK of CH2 is enabled and external modulation
source is selected, this connector accepts an external modulation signal
which polarity can be set by users.
— Trig In: when Sweep or Burst of CH2 is enabled and external trigger
source is selected, this connector accepts an external trigger signal which
polarity can be set by users.
—
Trig Out: when Sweep or Burst of CH2 is enabled and internal or manual
trigger source is selected, this connector outputs the trigger signal with
specified edge type.
For more detailed information about the signals mentioned above, please refer
to the User’s Guide.
3. [10MHz In/Out]
It is a BNC (female) connector which nominal impedance is 50Ω. The function of
this connector is determined by the type of the clock source.
—
When internal clock source is selected, this connector (used as 10MHz Out)
outputs the 10MHz clock signal generated by the internal crystal oscillator
inside the generator.
— When external clock source is selected, this connector (used as 10MHz In)
accepts an external 10MHz clock signal.
This connector is typically used to synchronize multiple generators. For more
detailed information about the signals mentioned above, please refer to the
User’s Guide.
4. LAN Interface
Through this interface, the generator can be connected to your computer or the
network of your computer for remote control. An integrated testing system may
be built, as the generator conforms to the LXI-C class standard of LAN-based
instrument control.
5. USB Device Interface
This interface is used to connect a computer which can control the generator
remotely using PC software or by programming. It is also connected to a
PictBridge printer to print the content displayed in the screen.
6. AC Power Socket
The AC power supply specification of this signal generator is 100-240V,
45-440Hz. The maximum input power of the instrument cannot exceed 30W.
The specification of the fuse is 250V, T3.15A.