RIGOL DG1000Z Series - Manual (Page 55)

RIGOL
DG1000Z Quick Guide 11
Power On and Inspection
To Connect to Power
Please connect the generator to AC power supply using the power cord supplied in
the accessories as shown in the figure below. The AC power supply specification of
this generator is 100-240V, 45-440Hz. The maximum input power of the instrument
cannot exceed 30W. When the signal generator is connected to AC power supply via
this connector, the instrument select the correct voltage range automatically and
users do not need to select the voltage range manually.
Figure 3 Connect to Power
CAUTION
To avoid electric shock, make sure that the instrument is correctly
grounded.
Power-on Inspection
After the power supply is correctly connected, press the power key
at the front
panel to turn on the generator. During the start-up, the instrument performs
initialization and self-test. After that, the instrument enters the default interface. If
the instrument does not start normally, please refer to the “Troubleshooting”.
To Set the System Language
DG1000Z series function/arbitrary generator supports Chinese and English system
languages. You can press Utility  Language to switch the system language.