Rose Electronics MultiStation - Manual (Page 12)

6 MULTISTATION INSTALLATION AND OPERATIONS MANUAL
Front panel – model ML-4U
Figure 3. ML-4U Front Panel
Table 3. Front panel - model ML-4U
Dip Switch
Configuration
Enables commands from keyboard at each KVM station. Up is
enable, down is disable.
KVM1 – dip switch on the right
KVM2 – dip switch 2nd position from right
KVM3 – dip switch 3rd position from right
KVM4 – dip switch 4th position from right
Power LED
When lit indicates the unit is powered on. The power is controlled by
a switch on the rear panel and an external power transformer
adapter supplied with the unit.
Status LEDs
Flashes once a second to show unit is on-line. This model internally
consists of two boards. The one-second flashing indicates the
boards are communicating with one another. Also flashes when
keyboard or mouse activity occurs.
Remote Video
LED When lit the CPU is sending video to KVM2, KVM3, and KVM4
Keyboard-
video-mouse
(KVM)
connectors Keyboard, video monitor, and mouse are connected at this port
using a keyboard-video-mouse adapter cable. The cable has a
DB25 male at one end and appropriate connectors at the other end,
depending upon your keyboard, video, and mouse type
Computer
connector
Your computer is connected at this prt using a computer adapter
cable. The cable has a DB25 male at one end and appropriate
connectors at the other end, depending upon your keyboard, video,
and mouse type*
* See Appendix C for further cable information.
Remote Video LED
Dip Switch Status LEDs
Power LED Keyboard-Video- Computer connector
Mouse connectors