Rose Electronics MultiStation - Manual (Page 14)

8 MULTISTATION INSTALLATION AND OPERATIONS MANUAL
Front panel – model MLK-2U
LOCAL
UNIT
REMOTE
UNIT
Figure 5, MLK-2U Front Panel
Table 5. Front panels - model MLK-2U
Dip Switch
Configuration
Only present on the local unit. Enables commands from keyboard at
each KVM station.
Up is enable, down is disable.
Local KVM – dip switch on the right
Remote KVM – dip switch 2nd position from right
Power LED
When lit indicates the unit is powered on. The power is controlled by a
switch on the rear panel and an external power transformer adapter
supplied with the unit.
Status LEDs
Flashes once a second to show unit is on-line. The one-second flashing
indicates the local and remote units are communicating with one
another. Also flashes when keyboard or mouse activity occurs.
Remote Video
LED Only present on the local unit.
When lit the CPU is sending video to the remote unit.
Keyboard-
video-mouse
(KVM)
connectors Keyboard, video monitor, and mouse are connected at this port using a
keyboard-video-mouse adapter cable. The cable has a DB25 male at
one end and appropriate connectors at the other end, depending upon
your keyboard, video, and mouse type
Computer
connector
Your computer is connected at this port using a computer adapter cable.
The cable has a DB25 male at one end and appropriate connectors at
the other end, depending upon your keyboard, video, and mouse type*
* See Appendix C for further cable information.
Dip Switch Remote Video LED
Status LEDs
Power LED Keyboard-Video- Computer connector
Mouse connectors
Status LEDs
Power LED Keyboard-Video-Mouse connectors