Rose Electronics UltraMatrix AV VGA 8 - Manual (Page 17)

SAFETY
UltraMatrix AV Installation and Operations Manual
13
Safety
The UltraMatrix AV has been tested for conformance to safety regulations and requirements, and has been certified for
international use. Like all electronic equipment, the UltraMatrix AV should be used with care. To protect yourself from
possible injury and to minimize the risk of damage to the Unit, read and follow these safety instructions.
Follow all instructions and warnings marked on this Unit.
Except where explained in this manual, do not attempt to service this Unit yourself.
Do not use this Unit near water.
Assure that the placement of this Unit is on a stable surface.
Provide proper ventilation and air circulation.
Keep connection cables clear of obstructions that might cause damage to them.
Use only power cords, power adapter and connection cables designed for this Unit.
Keep objects that might damage this Unit and liquids that may spill, clear from this Unit. Liquids and foreign objects
might come in contact with voltage points that could create a risk of fire or electrical shock.
Do not use liquid or aerosol cleaners to clean this Unit. Always unplug this Unit from its electrical outlet before cleaning.
Unplug this Unit refer servicing to a qualified service center if any of the following conditions occur:
 The connection cables are damaged or frayed.
 The Unit has been exposed to any liquids.
 The Unit does not operate normally when all operating instructions have been followed.
 The Unit has been dropped or the case has been damaged.
 The Unit exhibits a distinct change in performance, indicating a need for service.
Safety and EMC Regulatory Statements
Safety information
Documentation reference symbol. If the product is marked with this symbol, refer to the product
documentation to get more information about the product.
WARNING
A WARNING in the manual denotes a hazard that can cause injury or death.
CAUTION
A CAUTION in the manual denotes a hazard that can damage equipment.
Do not proceed beyond a WARNING or CAUTION notice until you have understood the hazardous conditions and have
taken appropriate steps.
Grounding
These are Safety Class I products and have protective earthing terminals. There must be an un-interruptible safety earth
ground from the main power source to the product’s input wiring terminals, power cord, or supplied power cord set.
Whenever it is likely that the protection has been impaired, disconnect the power cord until the ground has been
restored.
Servicing
There are no user-serviceable parts inside these products. Only service-trained personnel must perform any servicing,
maintenance, or repair.
The user may adjust only items mentioned in this manual.