Rose Electronics UltraMatrix AV VGA 8 - Manual (Page 5)

INTRODUCTION
UltraMatrix AV Installation and Operations Manual
1
Disclaimer
While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for
errors or omissions. Neither does the manufacturer assume any liability for damages resulting from the use of the
information contained herein. The manufacturer reserves the right to change the specifications, functions, or circuitry of
the product at any time without notice.
The manufacturer cannot accept liability for damages due to misuse of the product or other circumstances outside the
manufacturer’s control. The manufacturer will not be responsible for any loss, damage, or injury arising directly or
indirectly from the use of this product.
(See limited warranty)
Introduction
Thank you for choosing Rose Electronics
®
UltraMatrix AV™ for your audio and VGA video switching requirements. The
UltraMatrix AV is d esigned especially for control rooms, audio/video presentations, security centers and many other
digital media applications.
The ease of switching audio and video sources makes the UltraMatrix AV a versatile and flexible addition to your
system. Up to 8 video sources and 8 audio sources can be switched to any selected output port. The audio is
automatically switched with the video source. The video and audio switching can be controlled by an IR controller, the
RS232 input using a PC Windows based software, or the front panel display.
The UltraMatrix AV supports HDTV resolutions up to 1920 x 1200 for high quality imagery and video and full stereo
audio with a frequency response of 20Hz to 20 KHz.
Repetitive switching sequences can be recorded and saved in 1 of 50 macros for playback at any time.
Installation consists of two procedures:
1. Connecting the equipment
a. Computer videos
b. Audio sources
2. Installing the access software for controlling the UltraMatrix AV.
Each computer’s video is connected using a HD15M to HD15M cable
Each computer’s audio is connected using a standard 3.5mm stereo audio cable
The access software makes switching the selected input to an output fast and easy. Just click on the input source and
then the output destination and the video and audio are instantly switched. The video and audio from a selected input
source are switched together to the output destination.
Features

Switch multiple video and audio signals to multiple monitors and stereo speakers

Route stereo audio together with the video signal to multiple outputs

Supports all video formats
(VGA / SVGA / XGA / RGBHV / SOG and others)

Video bandwidth of 200MHz

Supports HDTV resolutions up to 1920 x 1200

Save and playback up to 50 different Macro routing sequences

Click and switch intuitive software for audio and video switching

Add additional units to increase the number of monitors (up to 64) that can be switched to