Rose Electronics UltraMatrix AV VGA 8 - Manual (Page 9)

UltraMatrix AV Installation and Operations Manual
5
The RoseControl switching matrix is a dynamic matrix that will automatically adjust the number of inputs and outputs
selected on the “Configure Router” screen.
The switching matrix makes it easy to select and switch any input video and optional audio source to any output
destination. By clicking on a cross-point, you can route a single or multiple outputs to a single input source but an output
can only be connected to one input source.
In the example shown in Figure 3, Input 01 is connected to output 01, 02, and 05.
Figure 3. Rose Control Switching Matrix
The input names (In 01 – In 08) and the Output Names (Out 01 – Out 08) can be changed to a name that identifies the
video source and destination. In 01 could be videofeed1, In 03 could be Computer 6, In 04 could be DVR player, etc.
The output names can also be changed to identify the display location or function.
To select multiple outputs to connect to a single input, hold the control (Ctrl) key down and click
on the individual output numbers needed. Next, click on the input number to route to the selected outputs.
Example:
To route outputs 1, 3, 5, and 7 to input #2, hold down the control key, click on the output numbers 1, 3, 5, and 7.
When all outputs are selected, click on input number 2.
To select multiple adjacent outputs to connect to a single input, click on the first output number, hold down the
shift key, then click on the last output number.
Example:
To route outputs 1-4 to input #3, click on output number 1, hold down the shift key and click on output number 4, then
click on the input #3.
To route a single input to all outputs, hold down the control key and click on an input number.
Example:
To route input #7 to outputs 1-8, hold down the control key and click on the input #7. Outputs 1-8 will be routed to input
#7.