TA Triumph-Adler FAX 970 - Manual (Page 14)

Installation
1-5
Op
er
a
ti
o
n
Set
ti
ng
s
Qu
ic
k u
sa
g
e
D
ir
ect
or
y
M
a
in
te
n
anc
e
Saf
et
y
Cont
en
ts
In
st
a
lla
ti
o
n
Date en cours : 8 janvier 2001
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\ARCHIVAGE DOC\MFK 23260964-8 36xx Sagem GB\Installation.fm
,
167$//,1*

<285

7(50,1$/
,QVWDOODWLRQUHTXLUHPHQWV
A proper location helps to ensure that your printer provides you with the long service life for
which it is designed. Double-check to make sure that the location you select has the following
characteristics.
• Choose a location that is well-ventilated.
• Make sure there is no chance of ammonia or other organic gasses being generated in the
area.
• The power outlet you plan to connect to for power should be nearby and unobstructed.
• Make sure that the printer is not exposed to direct sunlight.
• Avoid areas in the direct airflow of air conditioners, heaters, or ventilators, and areas subjec-
ted to temperature and humidity extremes.
• Choose a sturdy, level surface where the printer will not be exposed to strong vibration.
• Keep the printer away from any objects that might block its heat vents.
• Do not locate the printer near curtains or other combustible objects.
• Choose an area where there is no possibility of the printer being splashed with water or
other liquids.
• Make sure that the surrounding area is clean, dry, and free of dust.
2SHUDWLRQDO3UHFDXWLRQV
Note the following important precautions whenever using the printer.
Operating Environment
The following describes the operating environment required when using the printer:
• Temperature:
10°C to 35°C (50°F to 95°F) with fluctuation of 10°C (18°F) per hour.
• Humidity:
15% to 85% with fluctuation of 20% per hour.
Terminal
The following describes precautions for using the printer.
• Never turn the printer off or open any of its covers during a print operation.
• Never place flammable gasses, liquids or objects that generate magnetic forces near the
printer.
• When unplugging the power cord, always grasp the plug and never pull on the cord. A
damaged cord creates the danger of fire or electrical shock.
• Never touch the power cord when your hands are wet. Doing so creates the danger of elec-
trical shock.
• Always unplug the power cord before moving the printer. Failure to do so can damage the
power cord, creating the danger of fire or electrical shock.
• Always unplug the power cord if you do not plan to use the printer for a long time.
Installation.fm Page 5 Lundi, 8. janvier 2001 11:54 11