TA Triumph-Adler FAX 970 - Manual (Page 97)

6-20
Maintenance
Date en cours : 6 décembre 2000
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFK 23260964-8 36xx Sagem GB\Maintenance.fm
0
,6&(//$1(286

,1&,'(176
At switch-on nothing appears on screen
Check that the mains cable is plugged in, and check the mains plug if necessary.
The message N O P RINTER is displayed.
Check that the power switch of the printer is in the I (On) position (refer to paragraph Printer
connection, page 1/12).
The fax does not detect the presence of your inserted document. The message R EADY
does not
appear on the screen.
At the start and during scanning, R EMOVE D OCUMENT
appears on the screen and the "On"
signal is red.
Remove the document or press key .
Check the thickness of the document (30 sheets of paper of 80 g/m
2
).
Iron out the sheets if needed.
Help the sheets along.
The fax machine does not receive any faxes
• If the icon "Fax" is off and the icon "Tel." is on, this means that the reception mode is set on
M ANUAL
. Set it to F AX
(refer to paragraph Reception modes, page 3/5).
Check that the telephone line cable is correctly plugged in and that there is a tone signal on the
telephone line.
• If the message N O P RINTER is displayed on the screen, check if it is switched on, and check
that the printer connection cord is correctly plugged into the printer’s and fax’s jack.
You receive a blank page
Make a photocopy of a document ; if it is correct then your fax is functioning normally. Call back
the subscriber and have him resend the document. It was probably sent with the sheet inserted
backwards.
You cannot send a fax
Check that the telephone line cable is correctly plugged in.
Check tonality by pressing key .
LIAISSE 23260966-9.book Page 20 Mercredi, 6. décembre 2000 5:45 17