Subaru Robin EX13 - Manual (Page 94)

- 5 -
Step Parts to remove Renarks and procedures Parts Fasteners
10
Throttle body,
Insulator (1) Disconnect the fuel pump pulse line from the throttle body .
(2) Leaving the wire harness plugged into the throttle body, disconnect
the EFI wire harness from the engine .
(3) Remove the harness ground (black) from the top of the crankcase .
(4) Disconnect the engine temperature sensor (yellow) from the back
of the throttle bracket .
(5) Disconnect the low oil sensor lead (orange) and the power
generation lead (red) from the harness .
(6) Once the wire harness is completely free from the engine, remove
the throttle body with wire harness from the cylinder head .
Remove the insulator .
M5 tapping screw
+ screwdriver
10mm box spanner
M6 × 12mm : 2 pcs
STEP 10
INSULATOR
GASKET
GASKET
THROTTLE BODY
FUEL PUMP
PULSE LINE
M6 12 BOLT
M5 TAPPING
SCREW
WIRE HARNESS