Subaru Robin EX13 - Manual (Page 96)

- 7 -
3-4 REASSEMBLY PROCEDURES (DIFFERENCE)
(22) THROTTLE BODY
(a) Replace the gasket of insulator with a new one and mount the insulator on the cylinder head
intake side .
(b) Mount the throttle body keeping the wire harness plugged into the throttle body .
Re-connect the fuel pump pulse line from the throttle body . Leaving the wire harness plugged
into the throttle body, re-connect the EFI wire harness to the engine . Connect the harness
ground (black) to the top of the crankcase .
Connect the engine temperature sensor (yellow) to the back throttle bracket mounting hole on
top of the throttle bracket . Connect the low oil sensor lead (orange) and the power generation
lead (red) to the harness .
(26) FUEL TANK
(1) Connect the fuel pipe and fix it with a clamp .
(2) Connect the fuel pressure return pipe and fix it with a clamp .
(3) Mount the fuel tank on the crankcase .
Pulse
Air
cleaner
side
A
VIEW
A
THROTTLE BODY
Wire harness
Fuel
injection
Ignition coil
ECU
Injection
Yellow:
Speed control
bracket
Black:
(Earth wire)
Red:
Power coil
Black:
Stop switch
Orange:
Oil sensor
Inlet fuel
Return to
fuel tank
Return
Inlet to
fuel pump
Outlet
injection
Engine
side