Subaru Robin EA190V - Manual (Page 13)

10
3-3 AIR CLEANER
NOTICE: A dirty air cleaner will restrict air flow to the carburetor. To prevent carburetor malfunction, clean the air
cleaner each 50 hours (or three months) and service the air cleaner regularly. Service more frequently when operating the
engine in extremely dusty areas.
Using gasoline or flammable solvent to clean the filter element can cause a fire or explosion.
Use only soapy water or nonflammable solvent.
Never run the engine without the air cleaner. Rapid engine wear will result.
①
Screw off the connecting bolt and remove the air cleaner shell.
② Remove foam element or paper element. Be careful to prevent dirt and debris from falling into the air cleaner base
when opening,
③
Clean the element
Foam element: Clean the foam with detergent, and then blow it dry with compressed air or squeeze it dry. Dip the element
in clean oil, and then forcefully squeeze it dry and install it back.
Paper element: Tap the element lightly several times on hard surface to remove excess dirt or blow compressed air lightly
from the inside out. If dirty, replace in time.
CAUTION: Foam element containing too much oil will jam the foam element holes.
④
Check, clean or replace damaged air cleaner parts.
⑤ Reassemble the air cleaner element into the shell, install foam element or paper element back, cover the shell on and
screw in the connecting bolt.
3-4 Fuel parts
Don’t smoke or use flame fires near
the flammable solvent.
3-4-1 Strainer clean
(1) Drain the fuel into the container.
(2)Loose the clip, remove fuel tube and pull the strainer out.
(3) Check the strainer for damaged and clean the strainer in
the container.
(4) After cleaning, reinsert the strainer in the fuel tank,
connect fuel tube and tighten the clips.
NOTICE:
Check all connecting position for leaking.
Air cleaner shell
Air cleaner
element
Connecting bolt
Nut M6
Air cleaner base
Fuel tank
Tube
Strainer
Clip
Clip
Clip
Bolt M6×25
Tank cap
Tube
Clip
Fuel Gauge