Eiki XGA Diamond Series LC-XD25 - Manual (Page 26)

26
Computer Input
Choose either RGB or Computer 2 by pressing the
COMPUTER button on the remote control. Before using
COMPUTER button, correct input source should be
selected through Menu operation as described below.
Input Source Selection
Direct Operation
RGB
COMPUTER button
✳ See Notes at the bottom of this page.
✳
Remote Control
COMPUTER button
Computer 2
Input Menu
Input Menu
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Input Menu icon
Move the pointer (red
arrow) to Computer 2 and
press the SELECT button.
Move the pointer to RGB
and press the SELECT
button.
Source Select Menu
Computer
1
Press the MENU button to display the On-Screen
Menu. Press the Point
7 8 buttons to move the red
framed pointer to the Input Menu icon.
1
Press the Point ed buttons to move the red arrow
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
2
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button. 3
Menu Operation
✔ Notes:
• When the Input Search function is set On1 or On2,
the input signal will be searched automatically (p.46)
• Computer 2 is not displayed when the COMPUTER
IN 2/MONITOR OUT terminal is set as Monitor out.
(p.50)
• Computer 2 (COMPUTER IN 2 / MONITOR OUT) can
accept only RGB signal.
✳