Eiki XGA Diamond Series LC-XD25 - Manual (Page 54)

54
Setting
To Enter the PIN code
Select a number by pressing the Point ed buttons. And
then press the Point 8 button to fix the number and move
the pointer. The number changes to "✳". If you fixed an
incorrect number, move the pointer to the number you want
to correct by pressing the Point 7 button, and then select
the correct number by pressing the Point ed buttons.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to
"Set" by pressing the Point 8 button. Press the SELECT
button so that you can change the following PIN code lock
settings.
If you entered an incorrect PIN code, "PIN code" and the
number (✳✳✳✳) turns red. Enter a correct PIN code all
over again.
The PIN code can be changed to your desired four-digit
number.
Select "PIN code change" with the Point d button, and
press the SELECT button to display the New PIN code
input dialog box.
Select a number by pressing the Point ed buttons. And
then press the Point 8 button to fix the number and move
the pointer. Repeat it to complete entering a four-digit
number. After entering the four-digit number, move the
pointer to "Set" by pressing the Point 8 button. Then press
the SELECT button.
To Change the PIN code
CAUTION:
WHEN yOU HAVE CHANGED THE PIN CODE, WRITE
DOWN THE NEW PIN CODE IN COLUMN OF THE
PIN CODE NO . MEMO ON PAGE 74, AND KEEP IT
SECURELy . IF yOU FORGET yOUR PIN CODE, THE
PROjECTOR CAN NO LONGER BE STARTED .
Select Off, On1, or On2 with the Point 7 8 buttons and
then move the red framed pointer to "Quit" with the Point d
button. Press the SELECT button to close the dialog box.
To Change the PIN code lock setting
Change the PIN code
Select PIN code change and press
the SELECT button. The New
PIN code input dialog box appears.
The input numbers are being
displayed for confirmation.
Change the PIN code lock setting
Select a desired setting with the
Point 7 8 buttons.
Enter a PIN code
The input numbers change to "✳
" for security.
Move the pointer to "Set" by pressing
the Point 8 button. And then press the
SELECT button.