Eiki XGA Diamond Series LC-XD25 - Manual (Page 6)

6
CAUTION
Choose the running speed of cooling fans in the fan
control setting according to the altitude in which
the projector is being used (p.55). Failure to do so
may affect the projector life.
Safety Instructions
Openings in the cabinet are provided for ventilation and to
ensure reliable operation of the product and to protect it
from overheating, and these openings must not be blocked
or covered.
CAUTION
Hot air is exhausted from the exhaust vent. When using
or installing the projector, the following precautions
should be taken.
– Do not put any flammable object or spray can near
the projector, hot air is exhausted from the ventilation
holes.
– Keep the exhaust vent at least 3' (1 m) away from any
objects.
– Do not touch a peripheral part of the exhaust vent,
especially screws and metallic part. This area will
become hot while the projector is being used.
– Do not put anything on the cabinet. Objects put on the
cabinet will not only get damaged but also cause fire
hazard by heat.
Cooling fans are provided to cool down the projector.
The fans’ running speed is changed according to the
temperature inside the projector.
Air Circulation
Air Intake Vent
Air intake Vent
Exhaust Vent (Hot air exhaust)
Do not tilt the projector more than
20 degrees from side to side.
Do not point the projector up to
project an image.
Do not point the projector down to
project an image.
Do not put the projector on either
side to project an image.
Install the projector properly. Improper Installation may
reduce the lamp life and cause a fire hazard.
Installing the Projector in Proper
Position
20˚
20˚
USE CAUTION IN CARRyING OR TRANSPORTING
THE PROjECTOR
– Do not drop or bump the projector, otherwise damages
or malfunctions may result.
– When carrying the projector, use a suitable carrying
case.
– Do not transport the projector by using a courier or
transport service in an unsuitable transport case. This
may cause damage to the projector. To transport the
projector through a courier or transport service, consult
your dealer for their information.
– Do not put the projector in a case before the projector
is cooled enough.
Moving the Projector
When moving the projector, replace the lens cover and
retract the adjustable foot to prevent damage to the lens
and cabinet. When the projector is not in use for an
extended period, put it into the supplied carrying case
with the lens side up to protect the projector. The carrying
case (supplied) is intended for protection against dust
and scratches on surface of the cabinet, and it is not
designed to protect an appliance from external forces. Do
not transport the projector by courier or any other transport
service with this case, otherwise the projector can be
damaged.
When handling the projector, do not drop, bump, subject it
to strong forces, or put other things on the cabinet.
Exhaust Vent (Hot air exhaust)
Exhaust Vent
(Hot air exhaust)