Eiki XGA Diamond Series LC-XD25 - Manual (Page 50)

50
Setting
Ceiling
When this function is "On", the picture is top/bottom and
left/right reversed. This function is used to project the
image from a ceiling mounting the projector.
Rear
When this function is "On", the picture is left/right reversed.
This function is used to project the image to a rear
projection screen.
Ceiling
Rear
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the
back of the projector is switchable for computer input
or monitor output. (See page 9) Select Computer 2 or
Monitor Out with the Point
7 8 buttons.
Computer 2 . . . . . . computer input
Monitor Out . . . . . . monitor out
Terminal function is not available when selecting Computer
2 to the input source. Change the input source to the
others (Computer1 or Video) so that the Terminal function
will be available. (p.26, 37, 38)
Standby mode
This function is available when the projector is turned off
and in Stand-by. It is recommended to use Eco under
normal condition.
Normal . . . . . . . . . . nor mal power consumption in
Stand-by condition.
Eco. . . . . . . . . . . . . lower power consumption than
Normal mode in Stand-by condition.