Eiki XGA Diamond Series LC-XD25 - Manual (Page 46)

46
Auto setup
S e l e c t A u t o s e t u p
and this box appears.
C h o o s e t h e d e s i r e d
setting for Input search,
Auto keystone and Auto
PC adj. with the Point 7
8 buttons.
This function enables Input search, Auto Keystone
correction and Auto PC adjustment by pressing the AUTO
SETUP button on the top control. Settings for those
functions can be altered as follows:
Input search ✳
This function detects the input signal automatically. When
finding a signal, the search will stop. Use the Point
7 8
buttons to select one of the following.
Off . . . . Input search does not work.
On1 . . . Input search works under the situation below.
• When pressing the AUTO SETUP button on the top
control.
• When pressing the COMPUTER button or VIDEO
button on the remote control.
On2 . . . Input search works under the situation below.
• When turning on the projector with pressing the
POWER ON/STAND-BY button on the top control or
on the remote control.
• When pressing the AUTO SETUP button on the top
control.
• When pressing the COMPUTER button or VIDEO
button on the remote control.
• When missing the current input signal.
✳
• If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when
On-Screen menu is displayed
.
• While Input Search is set On1 or On2, the status of
Input and Lamp mode are displayed every time the
signal is switched.
• The signal input from S-VIDEO can not be detected.
• If any of the COMPUTER or VIDEO button on the
remote control, or AUTO SETUP button on the top
control is pressed while Input search is on, Input
search will stop.
Auto PC Adj .
On . . . . Enables Auto PC Adjustment when pressing
. the AUTO SETUP button on the top control.
Off . . . . Disables Auto PC Adjustment.
Auto Keystone
Auto . . . Always works and corrects keystone distortion
according to the projector's tilt.
Manual . Works only when pressing the AUTO SETUP
button on the top control.
Off . . . . Disables Auto Keystone.
✔ Notes:
• Input search, Auto PC Adj. and Auto
Keystone cannot be set "Off" at the
same time.
• Auto Keystone adjusts automatically
by pressing the AUTO SETUP button
either it is set on "Auto" or "Manual" in
setting menu.
• Au t o Key s t o n e c o r r e c t s ve r t i c a l
distortion only, not correct horizontal
distortion.
• The Auto Keystone cannot work when
Ceiling feature is set "On" in the Setting
menu (p.50).
• Pe r fe c t c o r r e c t i o n o f t h e i m a g e
distortion cannot be ensured with the
Auto setup function. If the distortion is
not corrected properly by pressing the
AUTO SETUP button, adjust manually
by pressing the KEYSTONE button
on the remote control or selecting
Keystone in the Setting menu (p.23,
47).
• Fine sync, Total dots, Horizontal and
Vertical position of some computers
cannot be fully adjusted with the Auto
PC Adjustment function. When the
image is not provided properly with
this operation, manual adjustments are
required (p.29–30).
Setting