Avago Technologies AcceleRAID 170LP - Manual (Page 25)

Installation
Manual No. DB11-000024-00 2-5
Connectors, LEDs, and Jumpers
There is one external and one internal Ultra 160 SCSI connector supported
on the AcceleRAID 170LP controller shown in Figure 2-1, labeled as CH 0.
The AcceleRAID 170LP controller has four LEDs on the front side as shown
in Figure 2-2 and described in Table 2-2. The LEDs indicate SE (single
ended), LVD, terminator enabled, and FAIL modes.
SCSI jumpers should normally be set to their default settings, no adjustments
are needed. Default jumper locations are shown in Figure 2-3 and are
described in Table 2-3.
When you have checked the termination requirements, completed the
connections of your desired SCSI devices, and other possible devices such as
a CD-ROM drive or a tape drive, close your system with the cover.
PCI Hotplug
☛
Note
Please see Appendix C for information on how to
implement the Hotplug feature for your system’s
requirements.