Raid migration, Rebuild, Redundancy – Avago Technologies AcceleRAID 170LP User Manual

Page 80: Replacement table, Risc, Rj-11, rj-45

Advertising
background image

G-22

AcceleRAID 170LP Installation Guide

Note: The host operating system drivers and software utilities remain
unchanged regardless of the level of RAID installed. The controller makes
the physical configuration and RAID level implementation.

RAID Migration

A feature in RAID subsystems that allows for changing a RAID level to
another level without powering down the system.

Rebuild

The process of reconstructing data from a failed disk using data from other
drives.

Redundancy

The inclusion of extra components of a given type in a system (beyond those
the system requires to carry out its functions).

Replacement Table

A table that contains information regarding which SCSI devices have been
replaced by others through standby replacement.

RISC

Reduced Instruction Set Computing, architecture for an application-specific
processor.

RJ-11, RJ-45

Registered Jacks (sometimes described as RJ-XX), a series of telephone
connection interfaces (receptacle and plug) that are registered with the U.S.
Federal Communications Commission (FCC). The most common telephone
jack is the RJ-11 jack, which can have six conductors but is usually
implemented with four. The RJ-11 jack is likely to be the jack that your
household or office phones are plugged into from the ordinary “untwisted”
wire (sometimes called “gray satin” or “flat wire”) that people are most
familiar with. The RJ-45 is a single-line jack for digital transmission over
ordinary phone wire, either untwisted or twisted; the interface has eight pins
or positions.

Advertising
This manual is related to the following products: