Avago Technologies AcceleRAID 170LP - Manual (Page 30)

Installation Process
2-10 AcceleRAID 170LP Installation Guide
Installing the Controller Into a Standard Chassis
If you are using a specially designed 2U chassis, see “Installing the
Controller Into a 2U Chassis” on page 2-11.
☛
Note
If the controller has the Low Profile PCI bracket
installed, replace it with the standard PCI bracket.
1. With the power off, plug (install) the AcceleRAID 170LP controller
firmly into any 32-bit or 64-bit PCI slot as shown in Figure 2-7.
Figure 2-7. Plug the Controller Board into any 32-bit or 64-bit PCI Slot
2. Go on to “Preparing the SCSI Drives” on page 2-12.
AcceleRAID 170LP
32-bit PCI Slot
Ground Clip
Ground
Wrist
Strap