Avago Technologies LSI SAS 3041E-R - Manual (Page 107)

CFGGEN Commands 6-9
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
•
<size> – Size of the RAID volume in megabytes, or MAX for the
maximum size available.
•
<SCSI ID> – SCSI ID of a hard disk drive to be included in the RAID
volume.
•
<enclosure:bay> – The enclosure:bay value for the disk drive to be
included in the RAID volume. These values can be obtained from the
output of the DISPLAY command.
•
qsync – If this optional parameter is specified, a quick
synchronization of new volume will be performed. If the volume type
is IME or IS, a quick synchronization is always performed even if
qsync is not specified. A quick synchronization means that the first
32 Kbytes of the drives in the volume are cleared to 0.
•
noprompt – Suppresses display of warnings and prompts.
Program Return Value –
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Specified adapter cannot be found.
6.3.4 DELETE Command
The DELETE command deletes all IM, IME, and IS volumes and hot
spare drives. No other controller configuration parameters are changed.
Command Line –
cfggen <controller #> delete [noprompt]
Parameters –
•
<controller #> – Number of the SCSI bus or SAS controller targeted
by this command.
•
noprompt – Suppresses display of warnings and prompts.
Program Return Value –
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Specified adapter cannot be found.