Avago Technologies LSI SAS 3041E-R - Manual (Page 82)

4-4 NetWare Drivers
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
4.1.4 Configuration IOCTL Interface Support
Support for the MPI IOCTL Interface (see LSI specification for details) for
NetWare is provided by the
LSICFGNW.NLM utility driver. This software in
conjunction with this driver provides an interface for management and
SCSI pass-thru utility applications. If your application requires this
functionality, the
LSICFGNW.NLM software must be loaded after the driver
instances are loaded. This can be accomplished by adding the following
line to the
startup.ncf file:
LOAD LSICFGNW.NLM
Only one instance of this NLM should be loaded. The NLM will
automatically attach to all of the adapter driver instances at that point. In
order for the
LSICFGNW.NLM software to load from the startup.ncf file,
it should be placed in the C:\NWSERVER directory on the DOS partition.
4.1.5 ASPI Support
NWPA ASPI support is provided via NetWare’s NWTAPE driver.
NetWare, or third party applications, may use this interface to
communicate with a SCSI device attached to an LSI MPT-controller,
including SCSI tape devices using NWTAPE.CDM.
4.2 Installing the NWPA NetWare Driver
To install NetWare, follow the instructions in the Novell NetWare
Installation Manual. The following information is provided to assist in the
installation. The LSI MPT NWPA NetWare driver must be loaded once
for each SCSI channel on an LSI controller installed in the system.
4.2.1 Preparing Your System for the NWPA Driver
The LSI NWPA driver, LSIMPTNW.HAM supports the following DOS
drivers:
•
ASPIMPT.SYS (Version 5.02 or greater)
•
SYMCD.SYS
•
SYMDISK.SYS