PLANET GS-4210-24P4C - Manual (Page 6)

6
4. Terminal Setup
The GS4210-8P2T2S, GS-4210-24P4C and GS-4210-24PL4C are equipped with a
console interface for local switch setup and maintenance. To configure the system,
connect a serial cable to a COM port on a PC or notebook computer and to the
RJ45 type of the console port of the Managed Switch.
Managed Switch
PC / Workstation
with
Terminal Emulation Software
Serial Port
RS-232 to RJ45 Cable
Console Port
RJ-45
Figure 4-1 Managed Switch Console Connectivity
A terminal program is required to make the software connection to the Managed
Switch.
1. Run terminal program on the OS.
2. When the following screen appears, make sure that the COM port should be
configured as:
z Baud : 115200
z Data bits : 8
z Parity : None
z Stop bits : 1
z Flow control : None
Figure 4-2 COM Port Configuration
Note
Console interface is not available for the GS-4210-8P2S, GS-4210-
48T4S and GS-4210-48P4S.